Eddy Solutions
Multi-family

Protect every resident, every floor.

Eddy is the managed water-protection service for multi-family residential buildings. Sensors at fixtures and risers, smart metering on the mains and a 24/7 monitoring center turn alerts into resolved incidents and the documented insurance outcomes that follow.

Modern all-glass residential high-rise against a clear sky.

Protect your property with Eddy

Reduce insurance costs

Documented mitigation moves the renewal conversation. Comparable properties have seen up to 20% in premium savings and up to $150K in deductible reductions.

Prevent leaks and water damage

Sensors at every fixture, riser and mechanical room. Smart meters on the mains. Anomalies surface before they become claims.

Shut off water remotely

Eddy Valve closes automatically per the runbook on the threshold or on operator command. SMS, email and app notifications page the building team in seconds.

Lower individual unit cost

Submetering replaces estimated bills with actual consumption. Residents see what they use and disputes drop alongside operating overhead.

Simple, powerful leak protection

Tier 01

Building protection

A base system with remote shut off valves, building network and sensors throughout the property.

Tier 02

Unit protection

Additional smart sensors within the suite placed next to at risk fixtures & appliances.

Tier 03

Smart metering

Smart meters for consumption billing data with leak detection algorithms to prevent leaks.

Tier 04

Construction protection

Protection during the course of construction to derisk construction sites and support better insurance.

Average concealed pipe leak in multi-family when undetected

Eddy 2025 portfolio

Common-fund exposure

Reduced

Documented mitigation lowers special-assessment risk

Risk profile

Events start in-suite. The bill follows.

Water events in multi-family compound across units fast, displacing residents and dragging the next renewal into hostile territory.

Eddy's monitoring center catches every event at the sensor. Zone isolation contains the incident at the suite or riser, so wings stay open and adjacent units stay dry.

Built for the spaces leaks start in.

Multi-family events compound across units. A failure on one floor reaches every floor below it before anyone responds. Eddy combines smart meters on the main and zone risers, point-of-leak sensors at every high-risk fixture and remote shutoff valves, all on one wireless network engineered for the back-of-house and the mechanical spaces other systems do not reach.

LoRaWAN at 915 MHz

Reaches mechanical rooms and elevator pits where Wi-Fi never did, with no extra cabling.

Continuous flow monitoring

Smart meters catch slow leaks and pressure anomalies before they cascade.

Predictive maintenance

Degrading fixtures surface in the dashboard before the next event.

Start your system

Build your system, one question at a time.

Build Your System is a guided builder. Pick the project stage to begin and it maps the sensors, valves and budget for your building.

  • Answer a few quick questions about the building.
  • Watch the recommended system and budget take shape.
  • Save the spec and share it with your team.
Open the builder
Build your systemStep 1 of 4

Pick the project stage to begin.

Free, no signup. Save and share your spec at the end.
Comprehensive in-suite coverage

What the comprehensive program protects.

Most multi-family water events start inside a resident suite, behind drywall, near fixtures and appliances. The comprehensive deployment tier extends the program to every high-risk in-suite source so the building reaches every leak path with a documented response.

87%
Multi-family leaks originating in resident suites

Behind drywall, near fixtures and appliances

65%
Leaks happening after-hours

When in-suite issues run silent

2 AM
Peak leak hour across the portfolio

The hour with the highest concentration of major leaks

Water Risk Intelligence

Compare your building to 2,557 monitored events.

Plug in your asset type, size and age. Get a risk score, the three drivers behind it and a brief you can hand to the board, the broker or the carrier.

Sample brief · your building

Elevated
  1. 01Response time
  2. 02After-hours exposure
  3. 03Source concentration

The worst losses in the report tracked response gap, not alert volume.

Source: State of Water Risk ‘26 report. Bands shown are a sample. Run yours to see your own.

Case studies

Multi-family wins with Eddy.

Real numbers from real buildings. Some are named; others are described generically for privacy. Pick one to read the full story.

11-storey condominium, Multi-family
Multi-family
Vancouver, BC11-storey condominium

An 11-storey condominium cut its insurance deductible by 80% in under a year.

80%reduction in insurance deductible, from $250,000 to $50,000

An 11-storey, 119-unit concrete condominium in Vancouver's Olympic Village retrofitted Eddy across HVAC, risers, fixtures and common areas. The deductible dropped from $250,000 to $50,000 inside the first year.

Read case study
Four-building condominium community, Multi-family
Multi-family
Vancouver, BCFour-building condominium community

A four-building condominium community saw a 25% premium reduction with no change to deductible.

25%reduction in insurance premium with no change to deductible

A 121-unit Vancouver complex spread across four buildings retrofitted zone monitoring, remote shutoff and a full-building wireless network. The result: $41K in estimated annual savings and 14 leaks mitigated each year.

Read case study
Four Seasons Residences, Multi-family
Multi-family
Two residential towersFour Seasons Residences

Four Seasons Residences: zero major incidents across two towers.

2–7 minaverage response time across both towers

Two luxury residential towers integrated Eddy's wireless leak protection with the Four Seasons concierge desk. Average response time runs 2 to 7 minutes. Suite displacements: zero. Estimated water damage savings exceed $450,000.

Read case study
Eddy-protected building, Multi-family
Multi-family
Montreal, QuebecEddy-protected building

A badly installed fixture could have leaked for months. It was isolated the same day.

Same dayInstallation defect isolated after detection

A resident-added fixture was not seated properly and began a slow leak under a bathroom sink, with no one to report it. Eddy detected the water near the sink, the source was identified as an installation defect, and the leak was isolated the same day with no spread.

Read case study
Eddy-protected building, Multi-family
Multi-family
Calgary, AlbertaEddy-protected building

A burst pipe, stopped the same second it started

ImmediateAutomatic shutoff the moment extreme flow was detected

A booster pipe failed on the third floor and dumped water with no one there to see it. Eddy detected the extreme flow and shut the water off automatically, confining a burst pipe to a small area before it reached a single suite.

Read case study
Eddy-protected building, Multi-family
Multi-family
Vancouver, British ColumbiaEddy-protected building

A drip behind drywall on an upper floor. Caught in seconds, sealed before it migrated.

SecondsConcealed in-wall leak detected

A concealed leak behind a fan coil on an upper floor looked like nothing from the room. A wireless sensor inside the wall cavity caught the moisture in seconds, and the superintendent sealed it before water could accumulate or migrate to other floors.

Read case study
Eddy-protected building, Multi-family
Multi-family
Ottawa, OntarioEddy-protected building

A fan coil failed in an empty suite. The line was isolated before anyone set foot inside.

RemoteAffected line isolated before prolonged loss

A failing fan coil pulled abnormal make-up water through the heating and cooling loop in an unoccupied suite. Eddy detected the abnormal flow, the affected line was isolated remotely before prolonged loss, and a plumber completed the repair.

Read case study
Eddy-protected building, Multi-family
Multi-family
Mississauga, OntarioEddy-protected building

A leak near the boiler tanks. Contained before it spread an inch.

0Spread to other areas

A flow-switch leak near the boiler tanks in a mechanical penthouse threatened the systems the whole building depends on. Eddy detected the water early, the leak was traced and contained quickly, and critical systems stayed online.

Read case study
Eddy-protected building, Multi-family
Multi-family
Toronto, OntarioEddy-protected building

A pressure-relief valve failed at 12:18 AM. The building never knew the difference.

12:18 AMOvernight failure detected the moment it started

A boiler-room pressure-relief valve failed in the middle of the night, with no one in the building to see it. Eddy detected the leak at 12:18 AM, reached the concierge within minutes, and the failed valve was isolated before water reached any occupied space.

Read case study
Eddy-protected building, Multi-family
Multi-family
Vancouver, British ColumbiaEddy-protected building

A slow drip the eye could never catch. Smart metering saw it anyway.

Off-hoursIrregular low flow detected automatically

A minor leak on a closed-loop cooling system showed up as continuous low flow on the make-up line, with nothing to see or hear. Eddy's smart metering flagged the abnormal pattern off-hours, and the superintendent isolated the chiller-room leak before it grew into a mechanical event.

Read case study
Eddy-protected building, Multi-family
Multi-family
Toronto, OntarioEddy-protected building

Two washing-machine events in one week. Both shut off automatically.

Under 1 minUnit valves closed after each alert

In a purpose-built rental tower protected from day one, two separate washing-machine events were intercepted in a single week. Each time the suite's water valves shut off automatically the moment the sensor triggered, containing both events to single suites.

Read case study
Eddy-protected building, Multi-family
Multi-family
Hamilton, OntarioEddy-protected building

Water under a dishwasher at 1:15 PM. It never left the suite.

1 suiteLeak contained, no spread to neighboring apartments

A dishwasher leak in a newly delivered community could have sent water down through several floors. A unit-level sensor caught it at the source, building staff confirmed it within minutes, and the event stayed inside the single suite.

Read case study

Get your property protected.

Work directly with our specialists to map your building's risk points and create a solution that addresses your needs.

Chat
Let's talk water risk